Lowrance - Evinrude Outboard Engine to NMEA2000 - Link Cable - interface - N2K

EVINRUDE engine interface cable 4.5 m (15 ft) and T-connector

This Cable is used to connect an EVINRUDEoutboard motorto an existing NMEA2000 network.

This will enable engine data to bedisplayed on your plotter:
Temperature, charge voltage, pressures, levels, trim,RPM, etc
NMEA2000 instrumentscan use engine data such as speed, fuel flow andtank levels to calculate range etc.

NMEA 2000 networks are easy to set up - here's the basics:
You can have up to 50 'T' pieces and drop cables.
The NMEA 2000 backbone must have a terminator at each end.
There must be one NMEA 2000 power cable.
Everything else is optional (including the backbone cable)